Eclipse Gen 2.0型号150-ECL

Specifications

Mixing Pressure Control Valve
Eclipse Gen 2.0 Cafsystem使用独立的专利的压力调节，其在发泡液的混合室中保持恒定的混合压力。该压力调节允许在GEN 2.0的最小工作压力高于泵排出压力的变化，而不会破坏系统的功能或改变熄灭剂的稠度。

Air Compressor
兰特空气端与锥形滚子轴承和三唇轴密封，油淹水，旋转螺杆型，尺寸至少为150个SCFM（4.25 m3 / min），至少125 p.s.i.g（8.6 bar）。

Pneumatic Modulating Inlet Valve
The air compressor is controlled by the pneumatic modulation inlet valve mounted on the air end. The pneumatic modulating inlet valve controls air delivery while maintaining constant pressure.

Fixed Air Pressure Operation
The compressor supplies a fixed air pressure supply to the foam generators at 116 PSI (7.8 Bar). Pressure balancing systems are not used or required.

- Fixed - Air pressure defaults to manual setting on compressor mounted control valve.
- Unload - Air pressure reduced to 40 P.S.I.G. (2.75 bar) for standby operations or when water only from the pump is required

Air Compressor Drive
The compressor is driven off the back of a standard Waterous pump transmission. The compressor drive is direct. The compressor shall be run in unload mode for pump testing and high pressure pump use. Power is transferred via a synchronous drive “toothed belt” with an adjustable tensioner. The system is designated to operate the air end at rated capacity when the fire pump is developing 130 to 140 P.S.I.G. (9 to 9.7 bar) in a “no flow” state.

Air Compressor Oil System
旋转开启的全流量油过滤器单元是系统的一部分，以控制对冷却器的油流量。所有油线都以编织软管布置，符合SAE 100R1用于液压软管的标准。

模块化空气/油分离器单元
Replacement elements for the oil filter and separator are available.

空气压缩机冷却系统
空气压缩机由含水泵1冷却，利用所有铜和黄铜壳和管热交换器。bob综合手机在线登录当消防泵正在运行时，水流通过热交换器，而在线可拆卸过滤器在进水侧，防止堵塞。该系统将油温保持在160°至225°F（71°至107°C）。

Foam Concentrate Piping
所有浓缩管道都是不锈钢，黄铜或高压线编织加强软管，带不锈钢或黄铜配件。

Foam Manifolds
Foam manifolds are constructed of cast iron. The manifold is a fully integrated assembly with foam injector port, flow meter mount and high-flow, low-loss, spring-assisted brass swing check valve to prevent back-flow of foam concentrate or foam solution into the pump.